Advertisement

For today's Mechanical Monday, we are taking a look back at the myths of tubeless tires. With all the rumors, both good and bad, about tubeless tires, it is about time to cut through the fluff and give a real accounting of this ever-growing technology. What are some of the common myths that need answering? We've compiled the list below:

Myth One: "Tubeless doesn't work."
Myth Two: "Any cyclocross tubeless tire will work."
Myth Three: "My Road Tubeless or 29er tubeless wheels will work just fine."
Myth Four: "You must use tubeless tires."
Myth Five: "Low PSI means faster."
Myth Six: "Wider rims are always better."
Myth Seven: "You need a compressor."
Myth Eight: "It’s always possible to change a tire the night before a race, or the morning of..."
Myth Nine: "Valves are all the same."
Myth Ten: "Low pressure is the only reason to try tubeless."
Myth Eleven: "Setup is complex and time-consuming."
Myth Twelve: "There are limited options for tires and rims."
Myth Thirteen: "Tubeless is heavier than tubulars, but lighter than clinchers."
Myth Fourteen: "If I can bottom out without burping, I’m good."
Myth Fifteen: "Tubeless is heavier than tubulars"

With top-tier riders like Mical Dyck finishing as the lead North American Elite Rider at the 2015 Cyclocross World Championship in Tabor, tubeless is becoming too relevant to ignore. For quality content like this tech article, be sure to subscribe to our print or digital magazine today, which is also available on Uberflip, in the App Store on iTunes, and on Google Play for Android.

If you find yourself pleasantly surprised by the dispelled myths, and the idea of going tubeless has piqued your interest, be sure to check out our earlier "how to" guide for going tubeless in Issue 25 as well.

8 of 14
Use your ← → (arrow) keys to browse

Myth Eight: “It’s always possible to change a tire the night before a race, or the morning of…”

Some tires with very tight beads may need to be stretched with a tube in the tire for several hours or overnight before the tire can be mounted tubelessly. Once a tire can successfully be mounted to a rim, the bead typically must be sealed and this takes a bit of time. Sealant needs time to cure and seal the tire completely and reliably. If the setup is a tubeless conversion, more patience is required since the sidewall of the tire must be sealed also. If you are assured the system holds air on the bike stand, then a field test is required to assure reliability before you embark on your race or adventure. That should include riding at various pressures over varied terrain.

Gunnar Shogren raced tubeless all season without issues but changed to a Maxxis Mud Wrestler before Masters Worlds in Louisville, and had a tubeless failure that cost him a chance at racing Tilford for the title.

You cannot depend on a last minute change for tubeless tires, so don’t pre-ride through a field of goat heads. © Cyclotourist on Flick’r

You cannot always depend on a last minute change for tubeless tires, so don’t pre-ride through a field of goat heads. © Cyclotourist on Flickr

8 of 14
Use your ← → (arrow) keys to browse